What are the maintenance skills for analyzing the bucket elevator belt?

The bucket elevator belt lifts and transports materials by vertically pulling the moving belt or chain structure, and the traction mechanism composed of the belt or chain is easy to be damaged in improper operation or long-term use. Therefore, when using the bucket elevator During the process, attention should be paid to correct operation and regular maintenance to ensure the normal use of the machine. Let's talk about the maintenance skills of the bucket elevator and how to maintain the elevator correctly.

1. Before each use of the bucket elevator, check the lubricating points of each component to keep the lubricating oil sufficient and the rotating parts lubricated smoothly. When the machine is started, it should run under zero load, and then feed the bucket elevator after idling for 2-3 minutes. It should be noted that the remaining materials in the hopper should be cleaned up before each shutdown, and no residue should be left After the material is cleaned up, stop the machine and do not reverse the traction mechanism to avoid derailment of the traction belt.

2. The feeding of the bucket elevator should be uniform, and it should not be too much or too little, and it should not exceed the rated conveying capacity of the elevator. Too much material will easily cause the hopper to bear too much load and fall off, and the material will accumulate. It is easy to cause the material to be unloaded uncleanly, to be lifted repeatedly, and to increase the energy consumption of the machine.

3. After the bucket elevator is used for the first time or repaired for 100 hours, it is necessary to re-check the machine, tighten all bolt joints, check the wear of each component, the filling of lubricating grease, and if the parts are severely worn, etc. Replace it in time, and debug the machine again, and it has achieved good results.

4. The maintenance and maintenance of the bucket elevator should be carried out regularly, and the machine should be overhauled regularly according to the specific usage and working environment, and corresponding records should be made. If the bolts are found to be loose or fall off at the bolt connection, and the traction belt and hopper are worn or damaged, they must be tightened or replaced with new parts in time, so as not to affect the normal use and efficient production of the machine.